./client/proxmark3.exe comX
It wasn't working because i was typing the commands in the MINGW32 and none of the commands works there, obviously !!!
So now everything is working fine!
It took some type but i figure it out!
Upgrade the Proxmark bootrom by executing the following command:
sudo ./flasher -b ../bootrom/obj/bootrom.elf
I haven't done that. It worked for the first time without doing that command
[Edit]
I'm on Windows, not on Linux
Are u using the proxmark client compiled together with the firmware and the bootrom? If not, plz use the client above; otherwise, check if u r running the client in sudo mode or you have correctly set the port number or even have correct drivers.
Everything is updated. Sudo mode? You mean that button?
How do i know if proxmark is in sudo mode?
[edit]
Which client ? The UI client ? No, im not using that one.
Thx for the reply
]]>Any help ? Plz !!!
]]>The switch is on. The led STD is lit and CHR is flashing, all the letters (A, B, C, D) are off
]]>