I believe that was indeed the reason that Elechouse released the product, because there was no fork required for the FW.
]]>in my thread for analyzing the ES1000 system was mentioned, that i dont have correct firmware.
From this page I used the link to a thread here in the forum.
But last version downloadable their is pm3-bin-2.4.0.
I purchased this one in june this year and it seems to be outdated.
Lab401 doesn't mention it and in their table was the difference, that the Evo is for desktop use optimised.
I'm currently using the Proxmark 3 Evolution with the latest git release build with the windows compiler:
hw version
#db# Performing i2c bus recovery
#db# I2C bus recovery error: SDA still LOW
#db# Performing i2c bus recovery
#db# I2C bus recovery error: SDA still LOW
Prox/RFID mark3 RFID instrument
bootrom: master/v3.1.0-134-g70dbfc3-dirty-suspect 2019-09-27 16:51:14
os: master/v3.1.0-134-g70dbfc3-dirty-suspect 2019-10-06 11:36:48
fpga_lf.bit built for 2s30vq100 on 2015/03/06 at 07:38:04
fpga_hf.bit built for 2s30vq100 on 2019/03/20 at 08:08:07
SmartCard Slot: available
uC: AT91SAM7S512 Rev B
Embedded Processor: ARM7TDMI
Nonvolatile Program Memory Size: 512K bytes. Used: 204806 bytes (39%). Free: 319482 bytes (61%).
Second Nonvolatile Program Memory Size: None
Internal SRAM Size: 64K bytes
Architecture Identifier: AT91SAM7Sxx Series
Nonvolatile Program Memory Type: Embedded Flash Memory
One problem is also that this pm recognize the 125kHz Card but not the transponders.
Using lf tune for voltage measuring:
Nothing on Proxmark Evo:
# LF antenna: 43.17 V @ 125.00 kHz
# LF antenna: 18.84 V @ 134.00 kHz
# LF optimal: 47.57 V @ 122.45 kHz
ES1000 Card:
# LF antenna: 38.22 V @ 125.00 kHz
# LF antenna: 22.55 V @ 134.00 kHz
# LF optimal: 38.22 V @ 125.00 kHz
Hitag S Transponder - factory new one:
# LF antenna: 42.62 V @ 125.00 kHz
# LF antenna: 20.49 V @ 134.00 kHz
# LF optimal: 43.31 V @ 123.71 kHz
My question now is, do I have to get the RDV 4.0 or can I go on with the evo?!
Thank you very much.
]]>