Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2009-02-24 13:24:02

DvD CPP
Member
Registered: 2009-01-22
Posts: 2

Proxmark USB driver

All,

I have 18 proxmark PCB made completly. But there is an problem I can flash the sam7 and the leds are working correctly. But when I attach the proxmark pcb in the USB port my computers do not see it. I have asked the component file to check if they have made an mistake. Does anyone have a clou? What it clould be..

Last edited by DvD CPP (2009-02-24 13:24:22)

Offline

#2 2010-10-05 14:42:46

notserpe
Member
From: Montreal
Registered: 2009-09-15
Posts: 14
Website

Re: Proxmark USB driver

For starters, what version of the firmware are you using (the SVN repo HEAD for example)?

I'm assuming you're talking about having flashed the SAM7 with JTAG, so can you see my post:
http://www.proxmark.org/forum/topic/644 … for-mainf/
and tell me the value you read for 0xfffffc24?

Can you tell me what part exactly you used for XT2 (the 16Mhz crystal)?

I don't think the current value for setting CKGR_PLLR in SVN has the correct MUL/DIV for my
hardware and maybe that's the case for you also.

Offline

Board footer

Powered by FluxBB