Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2016-01-07 17:45:29

zhovner
Contributor
From: Russia, Moscow
Registered: 2014-06-17
Posts: 15
Website

Standalone mode hf sniffer Save 14a snoop traces to Nonvolatile Memory

I try to build autonomous 14443A sniffer that goes into standalone mode immediately after boot, with no need to hold the button and that saves traces to nonvolatile memory so they will be accessible via USB after reboot. I faced two issues.

1. If put proxmark into standalone mode immediately after boot in AppMain() function there is impossible to connect it via USB.

2. How to save "hf 14a snoop" or "hf mf sniff" traces into nonvolatile memory? It is possible without soldering external SPI flash memory? Volatile memory buffer will be enough if it could be read in standalone mode without rebooting.

Maybe I need bind button to go back from standalone mode to normal mode?

Last edited by zhovner (2016-01-10 01:34:57)

Offline

Board footer

Powered by FluxBB