Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Just a heads up to those who have a PM3 v2 From elechouse.
on the PM3 v2 when you mount the Antennas like this i would get this reading from hw tune
# LF antenna: 45.10 V @ 125.00 kHz
# LF antenna: 20.35 V @ 134.00 kHz
# LF optimal: 46.20 V @ 123.71 kHz
# HF antenna: 27.51 V @ 13.56 MHz
Displaying LF tuning graph. Divisor 89 is 134khz, 95 is 125khz.
cannot do anything to small tags. proxmark read and writes Barely Worked..
now look at setup #2
after moving the antennas like this I get these readings.
# LF antenna: 35.20 V @ 125.00 kHz
# LF antenna: 23.51 V @ 134.00 kHz
# LF optimal: 35.89 V @ 126.32 kHz
# HF antenna: 27.47 V @ 13.56 MHz
Displaying LF tuning graph. Divisor 89 is 134khz, 95 is 125khz.
Now my tags detect, read, and write just fine!!
There must be enough Interference with the Board or the bend in the cable to make a difference in the voltage.
Basicaly 45v is too loud to write tags, Especially small ones like keyfobs.
Get it under 36v and i have not had any issues.
Thanks for the tip Marshmellow!
Offline
Hi,
I'm very interested by your configuration, but unfortunately I can't see the picture.
Am I the only one ?
Thanks
Offline
Id love to see the picture too, im having the same issue
Offline
@Apt-Get I have the same issue, can you please share the picture among forum members. Thank you!
Offline
let me see the picture too!
Offline
See this topic
Offline