Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2016-05-17 16:56:15

skappy
Contributor
Registered: 2014-01-13
Posts: 91

What kind of antenna should be used wih Mizip tag please ?

Dear All,
I would like to work on a mizip tag but i'm having hard time when trying to build a proper antenna...
I have find on the forum the example of a 1 mm enamelled copper wire (6 turns ), 2 cm diameter but it does not give sufficient juice on my PM3 ...
I have tried with different diameter but could not find something good enough for enabling communication ...
May i ask you help please ?
Thank you very much,
Have a great day

Offline

#2 2016-05-19 09:48:11

skappy
Contributor
Registered: 2014-01-13
Posts: 91

Re: What kind of antenna should be used wih Mizip tag please ?

Hello everyone,

Here is more information concerning my case ... smile

I would like to work on a  MIZIP type tag but the antenna that came with my proxmark 3 (hirose connector and loop) does not support this type of tag. It does not succeed in establishing communication.
May I ask Mizip users if they can specify what kind of antenna they are using please?
I tried to build several models of antennas loops but none issued more than 4.09 volts ....

Thank you very much for your help

Have a great day

Ps : Here is a picture of my "experimental" setting ...

198361FXSrt17.jpg



May I also ask owners of the proxmark 3 V2 (Elechouse) if they can communicate on the size of the pcb and the diameter of the copper wire used the HF Antenna please ?.
Thank you very much

Last edited by skappy (2016-05-19 09:54:54)

Offline

Board footer

Powered by FluxBB