Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Topic closed
#1 2017-08-08 21:56:35
- theguy
- Contributor
- Registered: 2017-08-08
- Posts: 52
Followed "Get Started" to a T and it doesn't work.
Followed the github instructions fully.
https://github.com/Proxmark/proxmark3/wiki/Ubuntu-Linux
Then tried to follow the http://proxmark.org/forum/viewtopic.php?id=1125 instructions, but at sudo ./client/proxmark3.exe or sudo proxmark3, I get "command not found". I'm in the proxmark3/client directory. The only files that start with proxmark3 are proxmark3, proxmark3.h, proxmark3.c. Sudoing them yields "command not found".
Please update the github "get started" to actually get the person started, and the I'm new! How do I use my Proxmark3 guides to carry the person past driver installation, to actually cloning an RFID card. Right now, they're woefully incomplete and inaccurate.
Offline
#2 2017-08-08 22:07:54
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,538
- Website
Re: Followed "Get Started" to a T and it doesn't work.
Welcome, you can now post your question in a relevant category. This is the introduction.
Offline
Pages: 1
Topic closed