Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2017-09-11 03:35:56

Mrbob35
Contributor
Registered: 2017-09-10
Posts: 3

Hello !

Just bout a ELECHOUSE Proxmark3 V2 DEV kits , pretty satisfied !

I'm Pretty new to these new challenged but  I already managed to clone an undocumented 125khz Card from paradox (but did not descramble the data) I Just clone the 96 FSK2 bits to a new T5577 Card ( and set the config bit accordingly)

Would be more then happy to share info if anybody need it

But
I'm still searching to get more info on hot to use the Board in autonomous mode , and how to assign the button to do something useful like  : read... demod... and log.. or spit out data in rs232 .

Any rough starting point would be appreciated tongue
I know script would be a good start . but still ...


Bob

Thanks !

Offline

#2 2017-09-11 09:25:28

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: Hello !

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Offline

#3 2017-09-11 16:18:31

Mrbob35
Contributor
Registered: 2017-09-10
Posts: 3

Re: Hello !

Thank for the auto reply. Already readed that:)

Offline

#4 2017-09-11 16:44:47

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: Hello !

I do take offence when ppl say I'm a bot...

Offline

#5 2017-09-11 18:39:59

Mrbob35
Contributor
Registered: 2017-09-10
Posts: 3

Re: Hello !

In this new era of artificial inteligence and machine learning I was thinking doing you a compliment smile

Offline

Board footer

Powered by FluxBB