Proxmark developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2017-11-23 03:07:00

natezoom
Contributor
Registered: 2017-11-22
Posts: 5

re-calling UIDs/ sniffing UIDs on battery

I have been messing around with the lf em 410xread command and was wondering if I could get the scanned UIDs when I plug it back it in.
Is there a way to read a UID em410x card on battery power and re-call it from the memory when you plug it in to the computer?

Offline

#2 2017-11-23 03:21:27

marshmellow
Moderator
From: US
Registered: 2013-06-10
Posts: 2,100

Re: re-calling UIDs/ sniffing UIDs on battery

No. Scan memory is lost when powered down.

Offline

#3 2017-11-23 03:54:11

natezoom
Contributor
Registered: 2017-11-22
Posts: 5

Re: re-calling UIDs/ sniffing UIDs on battery

marshmellow wrote:

No. Scan memory is lost when powered down.


How would can I get the scan memory if I dont power it down?

Thanks for your time,
Nate

Last edited by natezoom (2017-11-23 03:54:39)

Offline

#4 2017-11-23 05:12:01

marshmellow
Moderator
From: US
Registered: 2013-06-10
Posts: 2,100

Re: re-calling UIDs/ sniffing UIDs on battery

on some pm3 hardware and the current firmware this cannot be done at this time.

i heard somewhere someone was working on being able to plug in a rv2 pm3 on battery to a computer without resetting it.  but i'm not aware of their results.

as an alternative

there is a standalone mode for em410x that i believe can clone an em id to a t55x7.  but firmware has to be changed & flashed to turn it on.

or use a tablet/laptop or one of the phone clients and have it plugged in the whole time...

Offline

#5 2017-11-23 09:23:54

natezoom
Contributor
Registered: 2017-11-22
Posts: 5

Re: re-calling UIDs/ sniffing UIDs on battery

marshmellow wrote:

on some pm3 hardware and the current firmware this cannot be done at this time.

i heard somewhere someone was working on being able to plug in a rv2 pm3 on battery to a computer without resetting it.  but i'm not aware of their results.

as an alternative

there is a standalone mode for em410x that i believe can clone an em id to a t55x7.  but firmware has to be changed & flashed to turn it on.

or use a tablet/laptop or one of the phone clients and have it plugged in the whole time...

Where can I find that firmware? i thought it could only clone HID badges
thanks,
Nate

Offline

#6 2017-12-04 23:36:17

natezoom
Contributor
Registered: 2017-11-22
Posts: 5

Re: re-calling UIDs/ sniffing UIDs on battery

hello?

Offline

#7 2017-12-05 12:28:50

bogito
Contributor
Registered: 2017-10-18
Posts: 16

Re: re-calling UIDs/ sniffing UIDs on battery

natezoom, you can get the latest source from github, which includes the firmware. After that you can change/add the standalone mode you need and then re-compile & flash it on your pm3.

Offline

Board footer

Powered by FluxBB