Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
#1 2019-12-05 23:07:18
- 0xff0000
- Contributor
- Registered: 2019-11-18
- Posts: 4
SMA Adapter for PM3
With the proliferation of SDR platforms over the past 6+ years there are more options than ever for antennas.
Is anyone aware of adapters for handling hooking up a 50ohm antenna with an SMA connector to the classic Proxmark3?
I've read some pas threads (http://www.proxmark.org/forum/viewtopic.php?id=122) discussing this but in each case it's a beautiful and unique snowflake someone has built.
From a usability perspective it would be nice to have it hook up via the Hirose connector, but ultimately I'm open to whatever options folks could suggest (pogo pins on test points, a different PM3 model, etc).
The use case is actually to (VERY slowly) begin looking into different frequency ranges. I've been having a lot of success with the CF-5102 / LJYZN-105 units, but foresee some additional benefits which could come from more in-depth signal processing.
Offline
#2 2019-12-06 05:51:59
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,537
- Website
Re: SMA Adapter for PM3
I guess you would need to build a converter, that has hirose / SMA to fit to it. OR MMXC/SMA or USB/SMA depending on your Proxmark3 device. The RDV4 has screws on pcb. There is no unified antenna connector in the Pm3 ecosystem I'm afraid.
Offline
Pages: 1