Proxmark3 developers community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

#1 2011-10-16 07:39:45

asper
Contributor
Registered: 2008-08-24
Posts: 1,409

Question about USB protocol

Is there a document explaining ALL USB protocol commands (maybe with comments ?) and PM3 answers in order to send commands using VB ? (I mean "if I send 0001 the proxmark answer xxxyyyzzz etc.").

It is strange that no software exists other than proxmark.exe...

In the USB source code is also written "our protocol", does it mean that it is not public ?

Last edited by asper (2011-10-16 07:41:07)

Offline

#2 2011-10-22 13:08:50

asper
Contributor
Registered: 2008-08-24
Posts: 1,409

Re: Question about USB protocol

I managed to use libusbwin32_vb6 to communicate with proxmark and the demo software works ( scan_bus commadn is sent correctly and the device answers), but now I am stuck at "what exact command I must send" in order to receive data from Proxmark3 ? Any help ? I always receive errore -22 if I try to send something using UsbBulkWrite...

Last edited by asper (2011-10-22 13:09:03)

Offline

Board footer

Powered by FluxBB