Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Cloning NEXKEY
Last edited by Rfidman (2017-09-20 04:46:18)
Offline
So I assume you figured out the nexkey.
Offline
Yes, it was easy, i setup for T55xx, same Bit Rate and modulation, then i copied the first 4 blocks, and it works.
But i have another questions.
I need to change the NexWatch ID.
The first block specifies the Data Bit Rate, modulation and the blocks they transmit.
The NexWatch ID has 8 digits.
i dont have the format of the netkey.
Last edited by Rfidman (2017-09-20 06:33:21)
Offline
This is a card I am interested in learning more about as I have encountered some recently at a client site. I see there's not many prebuilt commands for it in the Proxmark software. I'm just at the beginning stages of learning how to get information from a card that doesn't already have a prebuilt command set.
I read the one long thread figuring out the demod. Any other resources you could point me toward?
Offline
Check the wiki and use the command help if available
Offline
Thanks, that was the first thing I did along with searching for other threads here. There's just not a whole lot
Offline
Pages: 1