Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2016-05-21 15:55:42

dimvia
Contributor
From: rf
Registered: 2016-01-13
Posts: 13

how to read in jcop the mode mifare emulation

UID :  xxxxxxxx       
ATQA : 00 04         
SAK : 28 [1]         
TYPE : JCOP31 or JCOP41 v2.3.1         
ATS : 10 78 80 70 02 00 31 C0 64 08 04 61 00 00 90 00 47 0D           
       -  TL : length is 16 bytes         
       -  T0 : TA1 is present, TB1 is present, TC1 is present, FSCI is 8 (FSC = 256)         
       - TA1 : different divisors are NOT supported, DR: [], DS: []         
       - TB1 : SFGI = 0 (SFGT = (not needed) 0/fc), FWI = 7 (FWT = 524288/fc)         
       - TC1 : NAD is NOT supported, CID is supported         
       -  HB : 00 31 C0 64 08 04 61 00 00 90 00           
Answers to magic commands (GEN1): NO 

hf mf rdsc 0 A xxxxxxxxxx
--sector no:0 key type:A key: xxxxxxxxxx
#db# Can't select card         
#db# READ SECTOR FINISHED         
isOk:00

Offline

Board footer

Powered by FluxBB