Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

Pages: 1

#1 2018-09-29 19:02:06

Spyder
Contributor
Registered: 2017-12-20
Posts: 21

Sorry for cross post [SOLVED]

Hi

How does the LF Antenna on the PM3 Easy connect to the main circuit board?

I can't see any obvious connectors.

Have looked and cannot find any references.

Thanks in advance

Last edited by Spyder (2018-10-02 18:18:37)

Offline

#2 2018-09-29 20:42:41

Violet
Contributor
Registered: 2018-09-13
Posts: 11

Re: Sorry for cross post [SOLVED]

The LF antenna connects through two of the metal screws / posts. Specifically, the pair of them in the middle of the Easy main board. On the antenna board, it's the two that are opposite where the USB connector are. There maybe a couple little 'arrows' or chevrons on the antenna board pointing to the two screws in question.

Offline

#3 2018-10-02 18:19:43

Spyder
Contributor
Registered: 2017-12-20
Posts: 21

Re: Sorry for cross post [SOLVED]

Thanks

See Hardware 125kHz Antenna Section for solution.

http://www.proxmark.org/forum/viewtopic.php?id=6008

Last edited by Spyder (2018-10-02 19:15:14)

Offline

Pages: 1

Board footer

Powered by FluxBB