Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2018-10-10 05:46:29
- TFK
- Contributor
- Registered: 2018-10-09
- Posts: 4
Flasher no such file or directory - Error
I am setting up my Proxmark3 RDV V2 from Elechouse on Windows 10.
The installation appeared to run fine with no errors but when attempting to flash the bootrom I received an error to say:
bash: /client/flasher: No such file or directory
I reviewed the file structure and the directory and file are present.
I assume it's not a driver issue or port issue as the Human Interface Device appears in Device Manager as does the Serial Com port on Com4.
I typed the command as I read it from the instructions:
/client/flasher com4 -b /bootrom/obj/bootrom.elf
Any guidance greatly appreciated.
Thanks
Offline
#2 2018-10-10 06:34:32
- gator96100
- Contributor
- From: Austria
- Registered: 2016-03-25
- Posts: 177
Re: Flasher no such file or directory - Error
I guess you are using ProxSpace on Windows 10, right?
Of cause /client/flasher does not exist, ist is./client/flasher com4 -b /bootrom/obj/bootrom.elf
There is no folder /client
Offline
#3 2018-10-10 06:51:10
- TFK
- Contributor
- Registered: 2018-10-09
- Posts: 4
Re: Flasher no such file or directory - Error
Thanks for the reply.
You are correct, it is ProxSpace on Windows 10.
Not sure I follow you though. I just checked the directory structure again and there is a client folder under
\ProxSpace-Master\pm3\client
and the file flasher.exe resides within it.
Am I missing something?
Offline
#4 2018-10-10 07:10:04
- gator96100
- Contributor
- From: Austria
- Registered: 2016-03-25
- Posts: 177
Re: Flasher no such file or directory - Error
/client is not a relative directory if you want to run the flasher that is in the client folder of your current directory you need a dot =>"./client/flasher com4 -b ./bootrom/obj/bootrom.elf"
On Windows /client would be equal to C:/client whereas ./client would be equal to <current dir>/cient
Last edited by gator96100 (2018-10-10 08:06:42)
Offline
#5 2018-10-10 07:58:21
- piwi
- Contributor
- Registered: 2013-06-04
- Posts: 704
Re: Flasher no such file or directory - Error
Likewise, another dot is required in front of the bootrom path.
Or you can omit the leading slashes.
Which instructions are you referring to?
Offline
#6 2018-10-16 08:21:09
- TFK
- Contributor
- Registered: 2018-10-09
- Posts: 4
Re: Flasher no such file or directory - Error
Sorry for the delay in my reply. Too much work and not enough free time. Thank you to both of you. I sorted it.
I haven't used Linux previously and my QNX is a little rusty and dated.
It's all up and running now so it's time to start experimenting!
Offline