Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Hi Folks,
I have a Mifare card where all the keys are known (Or so I think)
I can authenticate successfully on sector 0, 1 and 2. However in sector 2 I have an odd problem. I can read Block 8 and 9. However I cannot read block 10 or 11. It won't authenticate. I've tired the A and B key to no avail. It seems odd as the same keys are used for 8 and 9, and I can read these fine.
Hardware: ACR122U
Software: Bundled Software
On a side note, is there any good Windows / Linux software for easily reading cards? The bundle software with my reader is a little clunky.
Any insight?
Many Thanks,
ironclaw.
Offline
Try with MCmd
Regards.
Offline
Hi dxtno. Thanks for the reply. I tried MiCmd originally. I can't get it to read. It will connect, and authentication but then errors when one tries to read.
Offline
Pages: 1