Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
I saw a video on internet showing that someone use PM3 to take a sniffing in stand-alone mode and then connect it to a computer to collect data.I just want to ask how to switch from stand-alone mode to pc-connected mode，without data losing?In my opinion,the switch needs to disconnect the battery and connect the PC-USB line.HOW TO SAVE THE DATA SNIFFED JUST NOW FROM RUBBING BY RESTARTING?
anyone knows?
Offline
you need a 7205 ic to conect a batery and give up a 5v or used a 5v batery. then you need to iron in the pcb that batery, you could iron near the usb conector. the ends pins of the usb port ar +5vcc and gnd.
Or follow the electric lines from the usb and iron it where you want.
After that make a usb conector with only 2 pins, the central ones are the data pins.
Offline
Thank you,thefkboss.I will make a USB line following your advice!
Offline