Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Topic closed
#1 2017-09-11 03:35:56
- Mrbob35
- Contributor
- Registered: 2017-09-10
- Posts: 3
Hello !
Just bout a ELECHOUSE Proxmark3 V2 DEV kits , pretty satisfied !
I'm Pretty new to these new challenged but I already managed to clone an undocumented 125khz Card from paradox (but did not descramble the data) I Just clone the 96 FSK2 bits to a new T5577 Card ( and set the config bit accordingly)
Would be more then happy to share info if anybody need it
But
I'm still searching to get more info on hot to use the Board in autonomous mode , and how to assign the button to do something useful like : read... demod... and log.. or spit out data in rs232 .
Any rough starting point would be appreciated 
I know script would be a good start . but still ...
Bob
Thanks !
Offline
#2 2017-09-11 09:25:28
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,538
- Website
Re: Hello !
Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.
Offline
#3 2017-09-11 16:18:31
- Mrbob35
- Contributor
- Registered: 2017-09-10
- Posts: 3
Re: Hello !
Thank for the auto reply. Already readed that:)
Offline
#4 2017-09-11 16:44:47
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,538
- Website
Re: Hello !
I do take offence when ppl say I'm a bot...
Offline
#5 2017-09-11 18:39:59
- Mrbob35
- Contributor
- Registered: 2017-09-10
- Posts: 3
Re: Hello !
In this new era of artificial inteligence and machine learning I was thinking doing you a compliment 
Offline
Pages: 1
Topic closed